How to Winterize Your Pool (Warm vs. Cold Climate Guide)

Learn how to winterize your pool based on your climate. Simple, step-by-step instructions for warm, mild, and cold regions to protect equipment and prevent winter damage. When pool season winds down, a little prep goes a long way. Winterizing your pool protects your equipment, keeps your water in better shape, and makes spring opening much easier. The steps depend on where you live — so below, we break it down by climate.

Why Winterizing Matters

When water freezes, it expands by about 10%, which can crack pipes, damage pumps, and lead to costly repairs. According to the Pool & Hot Tub Alliance (PHTA), most winter damage happens because water wasn’t properly removed or protected. 

 

Even in warmer regions, skipping basic steps can lead to algae, staining, or equipment wear. 

Warm / Mild Climate Pool Winterization

If you don’t expect hard freezes, your goal is water balance and protection, not full shutdown.

Clean the Pool

  • Skim debris from the surface 
  • Vacuum the floor 
  • Brush walls and steps 
  • Empty skimmer and pump baskets 
  • A clean pool going into winter means fewer problems later. 

Balance the Water

Test and adjust: 

  • pH: 7.2–7.6 
  • Alkalinity: 80–120 ppm 
  • Calcium hardness: 200–400 ppm 

Once balanced, add a winter chemical kit (such as a Puri Tech Winter Kits) to help prevent algae and staining. )

Tip: Let chlorine or bromine tablets fully dissolve before closing. Leaving them in feeders can damage equipment. 

Cover the Pool

  • Use a weather-appropriate cover 
  • Secure it to keep debris out 
  • Check it periodically after storms 

In mild climates, covering helps keep the pool cleaner and reduces maintenance through winter. 

Cold / Freezing Climate Pool Winterization 

If temperatures regularly drop below freezing, you’ll need a full winterization. 

Clean the Pool

Follow the same cleaning steps as above. Don’t skip this — debris left behind can stain surfaces over winter. 

Balance the Water

Drain and Treat the Water

This step prevents freeze damage. 

  • Lower water below skimmers 
  • Drain pumps, filters, heaters, and chlorinators 
  • Blow out plumbing lines using a shop vac or air blower 
  • Remove and store drain plugs 

Clean and Store Filter

  • Sand filter: backwash thoroughly 
  • Cartridge or D.E. filter: remove, clean, and dry 
  • Store pressure gauges indoors 

Cover the Pool Securely

Above-ground pools: Use a winter cover kit and an air pillow to absorb ice expansion 

In-ground pools: Safety covers are recommended 

Make sure the cover is tight and free of tears before winter sets in. 

Helpful Extras (Worth the few extra-minutes)

  • Store ladders, rails, and accessories indoors 
  • Label small parts like drain plugs 
  • Take a quick photo of your setup for spring reference 

These little steps can save time and frustration later.